Skylight installation is a roofing job, not a window job. It requires cutting through your roof deck sheathing, framing a structural curb between the trusses or rafters, and building a weatherproof barrier with flashing, underlayment, and sealant. Whitman Roofing & Maintenance has been installing skylights in Whitman for 23 years — every one leak-free.
Tubular skylights are the alternative for spaces where a full skylight isn't practical — small bathrooms, closets, interior hallways. A 10-inch or 14-inch dome on the roof captures daylight through a reflective tube that channels it to a ceiling diffuser. Smaller roof penetration, simpler flashing, and effective daylighting in spaces a traditional skylight can't reach.
Our Skylight Installation Process
Site Assessment
We assess your roof from above and inside the attic. We locate the trusses and rafters, check the roof deck sheathing condition, and identify the best skylight placement for natural light based on sun angle, room layout, and roof pitch.
Structural Prep
Roof deck opening cut to exact dimensions. Structural curb built between rafters with doubled headers for load transfer. This is the foundation that holds the skylight and carries snow load — it's built to structural standards.
Flashing & Waterproofing
Full flashing system: ice-and-water shield base layer, step flashing and counter-flashing on all four sides, woven into the existing shingle field. Water flows over the flashing and onto the shingles below — never behind them.
Install & Insulate
Unit installed and sealed. Light shaft insulated and trimmed. We verify the seal from inside the attic — if we can see any daylight at the flashing joints, we re-seal before we leave. Your skylight is watertight and energy-efficient.
What Whitman Customers Say
"From the first phone call to the final walkthrough, everything was seamless. The team was courteous and efficient. Already recommended them to two friends."
"Responded fast and got the job done right the first time. Crew was polite, professional, and cleaned up everything. Would absolutely hire again."
"After getting several quotes, these guys stood out with their honesty and knowledge. No pressure, just straightforward advice and excellent workmanship."
Why Choose Whitman Roofing & Maintenance for Skylight Installation?
Code Compliant
Every skylight installation meets MA building code for structural framing, energy performance, and egress requirements. Permits pulled when required.
Insulated Light Shafts
Every skylight installation includes rigid foam insulation around the light shaft. Uninsulated shafts cause condensation and energy loss. We insulate, vapor-seal, and trim the interior for a finished look.
Brand Options
VELUX, Fakro, Sun-Tek — fixed, vented, and tubular models. Tempered and laminated glass. Built-in blinds and shades. We help you choose the right unit for your roof, room, and budget.
Leak-Free Guarantee
Every skylight gets ice-and-water shield, step flashing on all four sides, counter-flashing, and sealant at every transition. Verified from inside the attic before we leave. If it leaks, we fix it free.